2nd BRIEFING

WEEK 11

For this week, is given FYP2 briefing for the second time. The briefing 2 set at TTL1 and start from 3pm until 5pm. For the briefing is handle by Sir Azlan and Mdm Haslinawati.

Mdm explain detail about the project demo preparation to all student taken FYP2, she also mention about the Industrial Day that fall on Friday, 16 May 2014 start from 8am until 5pm. For degree students start in morning while diploma student start in evening. Mdm also have mention again about project presentation or demo is 40 percent.

Sir Azlan explain detailed about how to design the poster and how to present during industrial day. The poster should compulsory a few important detail which is introduction, objective, methodology, result and conclusion. After that Sir also have mention about colour of poster and format of poster. Also mention about submission form, metadata form and color of hard cover that have 2 type of colour. one is dark green is for diploma student and dark blue for degree student. Lastly talk about step to claim form of project, for diploma max RM300 and degree max RM500 only. After that talk about project submission form is needed to verify of supervisor and comment of supervisor.

MAKE A PROTOTYPE

WEEK 10

This week I try to find the wood to make a prototype and build it. I make a prototype that something like a house. Then put the hardware to the prototype.

Put the glue tembak to the hardware to make sure it will stick to the prototype.

finally!!

DONE WITH THE COMPLETE HARDWARE

WEEK 9

For this week I have complete interface the software with the hardware. This is how my project flow. Before touch the card, LCD will display “PLEASE TOUCH THE CARD”. User will have cards or tags registered card to access the system. The data is then sent as a packet using a two wire RS232 (or TTL) interface.When approached the card to RFID reader (approximately 6cm), the serial number of this card will be detected.A green LED will be lit and my name and ID number will be appearing in the LCD display, besides that output relay will active the solenoid high and after 5 seconds it will be active low back. Then LCD display will be reset and display “PLEASE TOUCH THE CARD” back Otherwise the system does not release the user access (unauthorized), a warning red LED will be lit and LCD will display “INVALID CARD”. During this process of release or rejection of users, characteristics beeps will be played on a buzzer (just like a sound announcement).